Top Navigation

Posi-Glaze List of Parts

MG Logo Full Width 1200px 300ppi JPEG

The below list of parts are suited to our Posi-Glaze frameless glass railing system

ImageNameProduct CodeDescription
Posi-Glaze Base Drilled ChannelPGC-010Posi-Glaze Base Drilled Glass Balustrade Channel. It is finished in a stainless steel effect by brushing and anodising the channel. The channel is drilled at 200mm Centres with a 14mm counterbored hole to suit M12 Hex-head bolts.
Posi-Glaze Side Drilled ChannelPGC-020Posi-Glaze Side Drilled Glass Balustrade Channel. It is silver anodised for protection against corrosion. The channel is drilled at 200mm Centres with a 28mm outer wall holes to a 14mm counterbored hole to suit M12 Hex-head bolts, this allows a socket to travel through outer hole to reach the M12 bolt head.
Top Bead - AluminiumPGA-030Aluminium Top Bead. Brushed and anodised in stainless steel effect to match channel. A rubber gasket is inserted into the rebate which pushes against the glass to prevent debris getting inside.
Posi Glaze Plastic Top BeadTop Bead - PlasticPGA-030PBlack Plastic Top Bead Co-extruded with gasket. It is an easy push on fit saving time on site removing the push in gasket.
Side CladdingPGA-010Aluminium Side Cladding. Brushed and anodised in stainless steel effect to match base drilled channel. A rubber gasket is inserted into the rebate which pushes against the glass to prevent debris getting inside.
Bottom CladdingPGA-020Aluminium Bottom Cladding. Brushed and anodised in stainless steel effect to match base drilled channel. Sealant to be applied in the channel rebates the cladding is lightly squeezed placed into the rebates and released to ensure it does not come off.
Clamp KitsPGB-00XXGlass adjustment clamp kits. A set of clamps and parts, including the gasket to suit a 3mtr length of our glass balustrade.
Accepts glass thicknesses from 12mm - 21.5mm with a 1mm tolerance.
90° CornerPGA-090Pre-Fab 90° Corner in brushed in stainless steel to match base drilled channel. Supplied with dowels to knock into position. Measures 135mm on the outer wall.
Joining DowelsPGA-070Aluminium knock-in dowels. These are used when joining two channel lengths together and align the side and heights. Pair required per join
End Cap - ThinPGA-060Laser cut end caps using 0.9mm stainless steel. Require adhering on to the channel ends
End Cap - ThickPGA-060RCast Stainless steel end cap. Cast with dowels one to slot into the channel using the normal dowel holes. Adhesive required
Pure Vista Glass Balustrade Drain BlockDrain BlockPV08DBPlastic drain block packer. A square plastic block with central hole designed to raise the channel by 8mm to allow water and debris to get underneath the channel. One block required underneath each bolt hole. Perfect for a retro-fit balcony
Spanner For Balustrade systemsSpannerPGA-050Posi Spanner. Angled adjustment spanner for tightening the adjustment bolts in the channel to put the glass in line on the top edge.